Scantronic 4603 Uživatelská příručka stáhnout pdf (Strana 5)

496368 Issue 1 5 of 12

Programming Commands

To change the factory default program use the commands listed in this

section as follows:

1. Key in the command number followed by Enter.

One of the LEDs on the display glows. The programming stencil shown

in Figure 3 (Part number 495521, Issue 1) shows the LEDs used by

each command.

Figure 3. Programming Stencil

2. Key in the appropriate value for the command followed by Enter. See

“Engineer Program Commands” for the values taken by each com-

mand.

The panel gives three short high-pitched beeps if it accepts the values

you enter.

If you enter an incorrect value the panel gives a longer, lower-pitched

fault tone.

When you complete a command correctly, the panel flashes all LEDs to

show that it is ready for another command.

Note: It is not necessary to program all the options. Where a change has to be made

to a particular option, proceed directly to the appropriate section. Refer to

factory default programming.

Defaults

When delivered from the factory the panel has the following defaults:

Engineering access code 7890.

User access code is 1234.

4600 Programming Commands

1 2 3 4 5 6 7 8 9 10 11 12

Žádné komentáře

Scantronic 4603 Uživatelská příručka Strana 5